The Ford Barn - View Single Post

mike42 · 09-25-2020, 02:58 AM

I forgot to tell you guys something......when drums were turned I asked about new bearings and seals. They recommended I replace them and I did so. Funny thing is....the Bearing Race made in China.....Bearing made in Japan......Seal made in USA ! Then to top it all off.....the small 3” link that goes between the lower adjustment bolts came in plastic bags with Bob Drake printed on them. The links were “USED” !!!! Not even cleaned up to at least look presentable ! Could not believe it, but thats the World we live-in !

Mike

09-25-2020, 02:58 AM	#17
mike42 Senior Member Join Date: Jun 2012 Location: Gaylord, Michigan Posts: 1,605	Re: 1940 Front Wheel Cylinders I forgot to tell you guys something......when drums were turned I asked about new bearings and seals. They recommended I replace them and I did so. Funny thing is....the Bearing Race made in China.....Bearing made in Japan......Seal made in USA ! Then to top it all off.....the small 3” link that goes between the lower adjustment bolts came in plastic bags with Bob Drake printed on them. The links were “USED” !!!! Not even cleaned up to at least look presentable ! Could not believe it, but thats the World we live-in ! Mike