The Ford Barn - View Single Post

barrelnose · 11-18-2019, 03:59 AM

Cheers for the replies,I figured it wasn’t a B model,I haven’t actually seen one in the flesh but was sure it would have the groove for the keeper if it was.
I wish I knew back when I was a young fella in NZ about the English fords,they were everywhere and I would of rounded up a few also.
And no,the shaft isn’t off centre,it’s bent. This one is junk really,to far gone.

11-18-2019, 03:59 AM	#19
barrelnose Member Join Date: Jul 2010 Location: Perth Hills Western Australia Posts: 58	Re: B model distributor question Cheers for the replies,I figured it wasn’t a B model,I haven’t actually seen one in the flesh but was sure it would have the groove for the keeper if it was. I wish I knew back when I was a young fella in NZ about the English fords,they were everywhere and I would of rounded up a few also. And no,the shaft isn’t off centre,it’s bent. This one is junk really,to far gone.