View Single Post
Old 03-30-2005, 12:51 PM   #1
Guest
 
Posts: n/a
Default Generator wiring




On a 48 59AB, what is the correct wiring setup for the generator I have mounted, in relation to the voltage regulator? I think I have it correct but just wanna make sure. Is it the ARM wire on the back plate, the FLD on the side, and the ground terminal right below this? With the engine running, should the FLD terminal (if it have it wired correctly) have volts going through it because my doesn't. I am so confused and frustrated in trying to find out if my battery is getting charged or not. Any guidance would be very welcomed!