The Ford Barn - View Single Post

borjawil · 02-21-2021, 01:53 PM

If I put all my shims on I'm probably at 130/40 ft/lbs and not hitting 20 in/lbs, lowest the torque wrench goes. Going to check my depth as my first reading was a bit shallow so I added a shim. If it's still shallow, adding a shim should tighten things up on the preload side.

I remove a .013 shim and it's too tight. That's the smallest shim.

Sent from my Pixel 3 XL using Tapatalk

02-21-2021, 01:53 PM	#12
borjawil Junior Member Join Date: Jan 2021 Posts: 25	Re: Dana 44 gear swap help If I put all my shims on I'm probably at 130/40 ft/lbs and not hitting 20 in/lbs, lowest the torque wrench goes. Going to check my depth as my first reading was a bit shallow so I added a shim. If it's still shallow, adding a shim should tighten things up on the preload side. I remove a .013 shim and it's too tight. That's the smallest shim. Sent from my Pixel 3 XL using Tapatalk