View Single Post
Old 03-16-2012, 06:03 PM   #4
Join Date: May 2010
Location: Federal Way, WA
Posts: 95
Default Re: !931 gas tank filler neck

Found the solder. It's all on the neck covered with RTV. Providing I can get the assembly clean enough for solder would I be well enough or better off using JB weld instead??

To get enough heat for a decent solder job I'd need to use a torch and have to deal with all the safety prep. Another pita with soldering is the upside down orientation and solder's tendency to run out the bottom when the parts are hot enough for it to flow well.

Anybody use other than solder??


Flat32 is offline   Reply With Quote