Re: leaking gas tank at steering column bracket
About 10 years ago my 29 Coupe was leaking in the area of this bracket.
NOTE: Brackets were riveted to tank for strength and then soldered to seal them.
Leak APPEARED to be under the bracket which was slightly loose.
Took the tank to a radiator shop with experience in soldering tanks. Sure enough the bracket was loose ... but they checked further.
They also found a 1/2 inch long crack about 3/4 of an inch away from the bottom edge of the bracket.
Owner said that he always strips the paint for about 1 1/2 inches around the bracket in all directions to look for cracks.
This was a VERY small leak where the gas kind of seeped out of the crack very slowly and could not be seen with the paint covering it up.
I also installed the 31 bracket and removed the rubber from the old bracket. I thought it would be good to leave the original bracket in case someone wanted to restore the original setup in the future.
NOTE: A small hole was drilled at each end of the crack to prevent crack from getting any longer.
Then a patch made from a sheet of brass was soldered over the crack.
Last edited by Benson; 03-04-2017 at 08:44 PM.
Reason: Additional info added in blue
|