08-02-2023, 07:32 PM
|
#7
|
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,894
|
Re: Bratton's Tool Box
Quote:
Originally Posted by ed thibodeau
I have one that when mounted follows the curve of the frame horn, so the front is
lower than the back. I opened a hole in the back in line with the crank hole with a small
cover over it. Lossen a screw and it swings out of the way and give access to crank
hole and is low enough in the front to clear the crank swing. It was made in lower Mich.
back inthe 90's. and works good.
|
I have the tool box that I believe you are referring to. I get a lot of compliments and questions. And yes, they are no longer being produced. I think they were sold thru Mike's.
Last edited by Y-Blockhead; 08-02-2023 at 07:37 PM.
|
|
|