Quote:
Originally Posted by DBSHELTON
OK, since I couldn't find an adjustable drag link to buy I measured my drag link at .629". So I ordered a 5/8"-18 left hand die nut (already had a right hand die). and a 5/8" adjusting sleeve. Was thinking about cutting out 1" or 1 1/2" and threading both ends. Anyone done this? Is this about right?
|
Have done the one using a Moog adjustable sleeve using the dies as posted on an old extra drag link. Cut enough threads but don't cut out too much of the drag to get the most support from the sleeve. Then fine tune trim the removed drag section as needed.