View Single Post
Old 10-06-2010, 11:19 PM   #8
Bill in SoCal
Senior Member
Bill in SoCal's Avatar
Join Date: May 2010
Location: Claremont, CA 91711
Posts: 244
Default Re: How to original Radius Ball Cap

Originally Posted by atourer View Post
Thanks guys, great help. Sorry but I am not convinced yet that 1 & 2 are rubber ball - I thought these were cast iron and completely enclosed the ball, but I could be wrong. No it's not a 32 bellhousing - it is a 29 single plate for sure. The 1/8" gap is making sense except it leaves the ball quite exposed to the elements methinks. I am confident to try it out on the car now thanks
Originals had a hole in the top for lubrication coming down from the flywheel cover (rear main leak).
Bill in SoCal is offline   Reply With Quote