View Single Post
Old 10-06-2010, 10:23 AM   #7
Chris in WNC
Senior Member
 
Chris in WNC's Avatar
 
Join Date: May 2010
Location: Spruce Pine, NC
Posts: 1,458
Default Re: How to original Radius Ball Cap

drawing on page 20 in Bratton's catalog shows the correct sequence of assembly.

the rubber ball only goes with the inferior quality cast caps, which WILL break.

stick with the stamped steel original type caps and put the cupped washer in as a temporary fix if the ball is worn, then replace the wishbone or repair the ball as soon as possible.....
Chris in WNC is offline   Reply With Quote