Thread
:
Trans shift fork shaft and plungers
View Single Post
02-23-2015, 08:26 PM
#
2
Tom Wesenberg
Senior Member
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Re: Trans shift fork shaft and plungers
The plunger shouldn't be touching that side of the shaft. They need to engage the notches on the other side, but it's good that you removed the little point left from machining.
Sponsored Links (Register now to hide all advertisements)
Tom Wesenberg
View Public Profile
Send a private message to Tom Wesenberg
Find More Posts by Tom Wesenberg