The Ford Barn - View Single Post

George/Maine · 12-13-2017, 07:08 PM

I think you will find the dot on other side.
I posted a pic of the gears and key that was in my motor book, and was brought to my attention is was trans backward.
I may have did the same thing trusting to old book, I also found the firing order was wrong.

Note using this book I think he put the gear on like to pic and It was correct but being 86 degs off. Grinder use the books for the specs.
That's my guess

12-13-2017, 07:08 PM	#135
George/Maine Senior Member Join Date: May 2010 Location: Mid coast Maine Posts: 1,878	Re: Rebuilt Flathead Problems. I think you will find the dot on other side. I posted a pic of the gears and key that was in my motor book, and was brought to my attention is was trans backward. I may have did the same thing trusting to old book, I also found the firing order was wrong. Note using this book I think he put the gear on like to pic and It was correct but being 86 degs off. Grinder use the books for the specs. That's my guess Last edited by George/Maine; 12-13-2017 at 07:36 PM.