The Ford Barn - View Single Post - Misnomer

duke36 · 05-07-2020, 10:09 AM

If the following parameters are met, engine angle @3 deg, alignment of front pulley viewed at radiator shell, etc. , then the close 1/64 to 1/32" coil spacing per the Service Bulletins adjustment may be challenging to fine tune with the nut and cotter. Also, assume the front yoke condition may be a variable.

05-07-2020, 10:09 AM	#19
duke36 Senior Member Join Date: Jun 2015 Posts: 1,414	Re: Misnomer - Front Engine Support If the following parameters are met, engine angle @3 deg, alignment of front pulley viewed at radiator shell, etc. , then the close 1/64 to 1/32" coil spacing per the Service Bulletins adjustment may be challenging to fine tune with the nut and cotter. Also, assume the front yoke condition may be a variable. Last edited by duke36; 05-07-2020 at 10:15 AM.