[rotorwrench]

Phosphor bronze is common in nearly all bushing materials for the type used in transmissions and other load bearing hinges. There is nothing misleading about what I stated. I choose not to hone the stuff but I don't dictate what others should do. That's why I recommended that folks brush out a honed bearing surface if they choose to go that route. That will at least remove any loose particles that may be lightly embedded in the surfaces.

I have purpose made reamers just for king pins and I don't use them very often so they are still very sharp even though they are pretty old. They align with a pilot for both sides and go all the way through in alignment. I keep them well oiled and store them in their original boxes when not in use.