View Single Post
Old 08-03-2020, 07:41 PM   #4
KiWinUS
Senior Member
 
KiWinUS's Avatar
 
Join Date: May 2010
Location: Charlotte NC KiWi-L100 available here
Posts: 2,101
Default Re: Wheel cylinder cleanup

I have wheel cylinder hones & dingle berry hones but I have a 6” long piece of 3/8 tubing with a slot cut I. One end. I take a sheet of red scotch brite cut it into 1 1/2 wide strip then slip one end into slot of tubing. I then twist it around tubing to make a hone cut it to length so the diameter fits cylinder & presto. Hone away for a great finish. Using drill of course with a liquid eg. solvent

Last edited by KiWinUS; 08-04-2020 at 06:15 AM.
KiWinUS is offline   Reply With Quote