View Single Post
Old 08-03-2020, 07:07 PM   #2
Bored&Stroked
Senior Member
 
Bored&Stroked's Avatar
 
Join Date: Jan 2011
Location: Central Ohio
Posts: 2,725
Default Re: Wheel cylinder cleanup

There is no problem using the standard brake cylinder hone - as if you don't tighten it down, it will just lightly hone the bores. Even if you crank it down, it takes a whole heck of a lot of continuous honing to remove any real amount of material. Go for it . . .

You can also use a "Ball Hone" that is designed for the cylinder sizes you have . . . but you end up having to buy a few of them as they are obviously not adjustable.
Bored&Stroked is offline   Reply With Quote
Sponsored Links (Register now to hide all advertisements)