The Ford Barn - View Single Post

elwood · 12-19-2020, 02:22 PM

Hey guys, Im repairing a set of doors, one of them the inner and outter skins are bad for around 2 to 3 inches up,
so i cut the skins off, as lest as possible, did the corner repairs, when test fitting the outter skin patch, and i can already tell that the outter skin on the door is wanting to curl inwards at the cut off.
how the heck do i get the original door metal to raise back up to meat the patch panel without having a dip at the seam ?

12-19-2020, 02:22 PM	#1
elwood Senior Member Join Date: May 2010 Location: Dallas Posts: 1,053	34 door help Hey guys, Im repairing a set of doors, one of them the inner and outter skins are bad for around 2 to 3 inches up, so i cut the skins off, as lest as possible, did the corner repairs, when test fitting the outter skin patch, and i can already tell that the outter skin on the door is wanting to curl inwards at the cut off. how the heck do i get the original door metal to raise back up to meat the patch panel without having a dip at the seam ?