Quote:
Originally Posted by Trey
Please post dimensions or pm them to me!!!!
|
OK guys, here are the dimensions. If there are any others I've neglected to note, let me know.
Overall length: 3.212"
Total shank length below hex (including threads): 2.063"
Total thread length (threads ONLY): 0.651"
Shank diameter (NOT tapered): 0.463"
Stub length (exposed knob-like part above hex): 0.933"
Stub diameter (tapers down FROM hex): 0.548" MAJOR to 0.538" MINOR (not visually noticeable)
Width (thickness) of hex surfaces: 5/32"-major // 1/8"-minor
Hex size (actual): 0.682".....for 11/16" wrench
Thread diameter (actual): 0.433"......(7/16-20 thread)
Transition radius from STUB to hex: Approx. 1/4" radius
One other note.....these pins insert from the REAR side of axle, where-as the I-beam pins insert from the front. That's because the STUB is built-in to these pins, where-as the stub surface for the I-beam pins is actually the acorn-shaped nut that threads onto those pins.