The Ford Barn - View Single Post

telase · 10-07-2010, 12:38 AM

I would like to go from mechanicals to hydraulics on the front axle of a 1935 1 1/2 ton truck...
would the backing plates and drums off of a say 48 to 55 large truck work on the 35 spindles?
what would be the best and simplest way to go?

would like to build a dependable and very usable 35 work truck with late model engine tranny and rear end, maybe even power steering ,
has anyone been down this road?
thanks
Telase

10-07-2010, 12:38 AM	#1
telase Junior Member Join Date: May 2010 Posts: 2	1935 1 1/2 ton truck front brakes I would like to go from mechanicals to hydraulics on the front axle of a 1935 1 1/2 ton truck... would the backing plates and drums off of a say 48 to 55 large truck work on the 35 spindles? what would be the best and simplest way to go? would like to build a dependable and very usable 35 work truck with late model engine tranny and rear end, maybe even power steering , has anyone been down this road? thanks Telase Last edited by telase; 10-07-2010 at 12:51 AM.