The Ford Barn - View Single Post

39topless · 08-17-2014, 04:09 PM

Martin, I am adjusting the two screws on the front base of the carb. I start the engine, turn the idle screw up to get some rpm's then adjust these two screws. I turn each one in until the engine begins to run rough, then back off until engine runs smooth. But these aren't the right ones? AAAARRRRGGGHHHHHH!!!!

08-17-2014, 04:09 PM	#23
39topless Senior Member Join Date: Sep 2013 Posts: 1,027	Re: adjusting 3 / 2's Martin, I am adjusting the two screws on the front base of the carb. I start the engine, turn the idle screw up to get some rpm's then adjust these two screws. I turn each one in until the engine begins to run rough, then back off until engine runs smooth. But these aren't the right ones? AAAARRRRGGGHHHHHH!!!!