[jfcrash]

Tom,

Are your intensions to make the new filler neck work?? From your photo with one on top of each other, you might try a muffler shop to use their hydraulic tubing bender to line them up.


As far as our part vendors… I am convinced there is one or two manufacturers and two or three wholesalers that our ‘favorite go to’ vendors buy from. Most can’t or won’t tell you where the part is made. I use Mac’s a lot cause they are 13 miles away and I can see it/compare it before I buy it. (In my limited experience …the most helpful/truthful folks I have dealt with has been Dick Spadaro’s V8 Reproductions…JMHO)

Jim