The Ford Barn - View Single Post

Henry Floored · 05-25-2014, 07:54 PM

Well I think if a part such as a block or crank is engineered in the USA and maybe cast overseas then brought back for machining and final quality control, I'm comfortable with that. Of course good quality control is a must in the overseas part too. That's just me though.

05-25-2014, 07:54 PM	#20
Henry Floored Senior Member Join Date: May 2010 Location: Florida Posts: 630	Re: New Flathead Engine Well I think if a part such as a block or crank is engineered in the USA and maybe cast overseas then brought back for machining and final quality control, I'm comfortable with that. Of course good quality control is a must in the overseas part too. That's just me though.