The Ford Barn - View Single Post - Distributor Mounting screw and locking nut

jw hash · 01-24-2014, 01:55 PM

take a 3/8 fine threaded bolt and cut it the same length as the screw turn the end down and just use a 9/16 wrench on it. be careful not to over tighten the bolt.

01-24-2014, 01:55 PM	#3
jw hash Senior Member Join Date: May 2010 Location: Auburn Washington Posts: 2,696	Re: Distributor Mounting screw and locking nut take a 3/8 fine threaded bolt and cut it the same length as the screw turn the end down and just use a 9/16 wrench on it. be careful not to over tighten the bolt.