The Ford Barn - View Single Post

rich b · 01-05-2014, 05:17 PM

Do you have the right length bolt, so it gets tight before bottoming out? The original bolt is pretty short.

Maybe feel in there and see if it just the joint moving the 1/4" or if the output shaft is moving also.

01-05-2014, 05:17 PM	#7
rich b Senior Member Join Date: May 2010 Location: Minnesota Posts: 2,156	Re: closed drive universal install Do you have the right length bolt, so it gets tight before bottoming out? The original bolt is pretty short. Maybe feel in there and see if it just the joint moving the 1/4" or if the output shaft is moving also.