Obviously if you use the switch, you've got to provide power to the pump until you've got oil pressure (probably before cranking to fill the carb). Older Chrysler products had a timing relay that energized the pump for 5 seconds after the ignition was energized, or when the starter was activated. That would be perfect but I can't find one.
http://www.holley.com/12-810.asp[/QUOTE]
Thanks Ross....but I've got a '40 Coupe and was just wondering where people prefer to pull the power for the switch, or pump? From the coil side of the ignition switch? Should a relay be used if not using the Holley switch?
Joe