Re: Jumping out of 2nd gear
Sorry, I don't have a diagram. The shims are listed in Bratton's catalog under p\n 9120, page 41. The catalog shows a picture of them. The shims are horse shoe shapped. They go on each side of the rear of the engine block. Loosen the two bolts that hold the accelerator linkage to the engine. Use a pry bar to open a gap where the ear of the clutch housing attaches to the block. Drop the shim in from the top. To check if they are there wipe the ears clean and you should be able to see the top edge of the brass shim if it is there.
Tom Endy
|