The Ford Barn - View Single Post

Joe Immler · 11-10-2013, 02:38 PM

Yes I have done this. When I first installed my E8902 I tested it and found that even though it was running no fuel was coming out at the fuel line into the engine. I knew for sure that the lines were good as everything was new. I pondered for awhile until i realizes the Ford was positive ground. I had wired it + and - per the connections on the pump. I reversed them and the pump runs fine. I don't recall my instructions mentioning wrapping the bracket. I didn't by the way.

11-10-2013, 02:38 PM	#2
Joe Immler Senior Member Join Date: Dec 2012 Location: Massillon, Ohio Posts: 786	Re: Airtex fuel pumps Yes I have done this. When I first installed my E8902 I tested it and found that even though it was running no fuel was coming out at the fuel line into the engine. I knew for sure that the lines were good as everything was new. I pondered for awhile until i realizes the Ford was positive ground. I had wired it + and - per the connections on the pump. I reversed them and the pump runs fine. I don't recall my instructions mentioning wrapping the bracket. I didn't by the way.