The Ford Barn - View Single Post - Rear End Gear Ratio--39 Ford

VeryTangled · 10-20-2013, 04:32 PM

Hello Jon Laing, the bolt you're asking about is the one sticking out the front end of the crankshaft. It's where the crank would go if you were hand-starting it. It should be just below the distributor. Facing the front of the car, turn it clockwise.

-VT/JeffH

10-20-2013, 04:32 PM	#8
VeryTangled Senior Member Join Date: May 2010 Location: (Not far enough...) Outside of DC Posts: 3,400	Re: Rear End Gear Ratio--39 Ford Hello Jon Laing, the bolt you're asking about is the one sticking out the front end of the crankshaft. It's where the crank would go if you were hand-starting it. It should be just below the distributor. Facing the front of the car, turn it clockwise. -VT/JeffH