The Ford Barn - View Single Post

HCO41 · 10-09-2013, 03:35 PM

This is a heads up! I went to the link 19Fordy posted above. You will notice that there are 3 taps shown but 7/16-14 was the only description. The link showed several suppliers of this (these?) items. I went to Jegs sight and the same group of three taps was shown. I specifically asked (Larry) if they were offering three taps or just the 7/16-14. He assured me that a 3/8-16 and a 1/2-13 were included. I ordered the taps.
When I got my confirmation it only showed the 7/16-14. I sent Jegs an inquiry via email and got a call from them. Guess what; "Larry made a mistake". I was then offered a five piece rethreading tap set for over $100.
Watch out!!!

10-09-2013, 03:35 PM	#30
HCO41 Senior Member Join Date: May 2013 Location: Lyndon, Vt. Posts: 462	Re: Cleaning threaded block holes This is a heads up! I went to the link 19Fordy posted above. You will notice that there are 3 taps shown but 7/16-14 was the only description. The link showed several suppliers of this (these?) items. I went to Jegs sight and the same group of three taps was shown. I specifically asked (Larry) if they were offering three taps or just the 7/16-14. He assured me that a 3/8-16 and a 1/2-13 were included. I ordered the taps. When I got my confirmation it only showed the 7/16-14. I sent Jegs an inquiry via email and got a call from them. Guess what; "Larry made a mistake". I was then offered a five piece rethreading tap set for over $100. Watch out!!!