I hope you guys dont feel I'm beating a dead horse here, just wanted to post what I'd found and the pics that I took last week.
A leakless rear bushing, showing the two lip seals, back-to-back, the roller bearing and the front lip seal. This one had a place for the bearing to take grease but the bushing wasnt drilled and the grease fitting was a dummy. Its a moot point anyway, the seals failed before the bearing did from lack of grease.
The shaft where the rear seal rode. After it was cleaned up you could see and feel the ridges worn by the lip seals. I tried to take a pic, but all you could see was the glare.