Quote:
Originally Posted by Bishop Welding
Not sure if the threads want to be oiled or dry when torque-ing, or if that is even a factor, but it seems like that may affect it. Maybe someone here has better information on this.
|
Hmm, never saw anyone 'oil' the threads...where the nut clamps down on the head. I use never seize on the lower portion on the stud hand threaded into block (to prevent studs from rusting in place).
I would think that the oil would change the originally intended (torque)twisting/tightening force..to who knows what effect
BTW why use used/questionable studs on an expensive job otherwise?
I may be overly cautious, but use the best new set of studs that I can get. I consider the wear/tear between the old stud and the block threads. I figure that some of that wear is taken up by use of new studs..no?