Re: For those who have T5s
Phoenix, I have a Ford toploader 4 speed with a Jeep shifter on it in the '36 project I'm working on. I used a Chassis Engineering center section that I modified the bottom plate to keep the ball mount rather than split the wishbone. To gain some clearance around the bottom of the trans, I got my hands on the ball mount from a Model A wishbone (pictured) and welded it in the '36 wishbone.
Also, even though I have semi-elliptical springs with open drive, I have kept the anti-chatter rods. I don't know if it matters, but I figure it can't hurt. I beef up the areas in the frame where the rods attach because they usually have stress cracks.
|