Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by 36tudordeluxe
Thanks everyone for responding, am using a CE rear end kit and have no plans at this point to lower the rear any more than what is provided with the CE kit.
|
I have a 9" in my '40 using a Chassis Engineering Inc. rear suspension system. The banjo is centered so the pinion is offset just under 1", but there are no floor/tunnel to the 3 1/2" drive shaft clearance issues with the axle fully bottomed against stock '40 axle bumpers. My design ride height is 3- 3 1/2" between the bumpers and axle.