Re: Front motor mount, somethings not quite right.
Thank you for your responses! I checked out Marco's site and the springs match the dimensions given, not sure about measuring the load but their physical size matches. I do not see anything regarding the yoke dimension though.
We just started a new club so I will see if I can convince someone into taking a look at it.
Do you think that this would be repairable with the engine installed or will it need to be removed? Maybe get by with removing the yoke and pulley and jacking up the engine a tad? Need to remove the radiator?
Also, does anyone have any measurements on the cross member? The hole is probably 1-1 1/2" in diameter right now.
Lastly is there a specific type of washer to use instead of the brass bushing?
Thanks again!
|