[ford3]

using the stud welder means you dont have to drill holes in the metal and insert a sheet metal screw in the hole to pull out the dent with the slide hammer, no holes, no welding them shut, a piece of advice of advice on using the stud welder, use a big pair of wire cutters to remove the studs, grip the head of the stud and twist back and forth to remove it, all that will be left will be a small bit of metal that can easily be sanded off, try not to use the slide hammer to bang the dent out, try pulling on the stud with it, most of the time the dent will come out and not leave a pucker( high top pucker) if you cant pull it out that way then use the slide hammer tool to bang it out