Quote:
Originally Posted by Terry, NJ
Anyone have any instructions on welding one of these up? Where to make the cut? What rod works best (70/ 8018LH?) Preheat? Cool slowly or quench? I am thinkingg of drilling it out and putting a 5/16 X 2" rod down the middle, in effect, a spine. Or weld a piece on the back where it can't be seen to bridge over the weld. Jest thinkin'!
Terry
|
Terry the way i did mine is cut a v take out 1and 1/2 preheat oven 450 the used cast iron rods build with each pass when done pack it in sand and let cool. done this with three none broke couple of thousand miles on each