The Ford Barn - View Single Post

columbiA · 11-24-2012, 07:36 PM

Back in 1955 when I needed a fuel pump for a B,I used one from a 6 cyl Chrysler product.All I did was heat & bend the rocker arm until it fit properly.Have the FP lobe facing out so that when the pump is pushed flush with the block it will pull the diaphragm down.When the gasket is installed the linkage wont bind.If the top of the pump is not facing the right way,remove the screws & turn top 1/2.when tightening the top 1/2,do it with the diaphragm pulled down.

11-24-2012, 07:36 PM	#4
columbiA Senior Member Join Date: Nov 2011 Location: B.C. Canada Posts: 1,746	Re: 32 bb 4cyl. fuel pump Back in 1955 when I needed a fuel pump for a B,I used one from a 6 cyl Chrysler product.All I did was heat & bend the rocker arm until it fit properly.Have the FP lobe facing out so that when the pump is pushed flush with the block it will pull the diaphragm down.When the gasket is installed the linkage wont bind.If the top of the pump is not facing the right way,remove the screws & turn top 1/2.when tightening the top 1/2,do it with the diaphragm pulled down.