Quote:
Originally Posted by Rich B.
Ro-Loc makes these nylon mesh disk's that twist on just the
sanding disk's. These things will really spoil you! They make gasket removal a piece of cake. I'm always fighting surface rust on my
lathe, and mill no matter how much I oil them. These spiff it up in minutes.
I'm sure if you tried hard enough you could remove some metal, but
I have no problem with them.
Rich
|
Those discs have a place but not near engines unless the engine is apart so they can be washed.They are made with aluminum oxide and it degrades as you use it and gets into the engine and if not washed out becomes the worlds best honing compound.Very difficult to control when the pistons are in the block.
My2¢
R