The Ford Barn - View Single Post

John Stone · 07-20-2010, 12:00 PM

Test run is over and it ran fine. With all the other things I found, the closing of the points just acted like the initial problem. Now I am convinced the initial culpret was the "Made in China" coil. I tested it and it showed bad when heated.

I have learned a lot about 12v conversions and what to expect when measuring resistance and voltage. Thanks guys. Hope I never have to use that knowledge again. LOL

Thanks again
John

07-20-2010, 12:00 PM	#16
John Stone Senior Member Join Date: May 2010 Location: Wichita, Kansas Posts: 710	Re: Can't seem to find the problem Test run is over and it ran fine. With all the other things I found, the closing of the points just acted like the initial problem. Now I am convinced the initial culpret was the "Made in China" coil. I tested it and it showed bad when heated. I have learned a lot about 12v conversions and what to expect when measuring resistance and voltage. Thanks guys. Hope I never have to use that knowledge again. LOL Thanks again John