The Ford Barn - View Single Post

Gary Tosel · 04-25-2012, 05:51 PM

Yes it is a square stock required, since it is threaded into the rod. There are some plug wrenches out there that have several different sizes that may have the correct one. Otherwise find a square stock and use a wrench or vice grips to remove. You may need to soak it with solvent before trying, since they can be difficult to remove.

04-25-2012, 05:51 PM	#3
Gary Tosel Senior Member Join Date: May 2010 Location: Minnesota Posts: 1,422	Re: Removing 36 Engine Side Support Yes it is a square stock required, since it is threaded into the rod. There are some plug wrenches out there that have several different sizes that may have the correct one. Otherwise find a square stock and use a wrench or vice grips to remove. You may need to soak it with solvent before trying, since they can be difficult to remove.