A trick for easier install... get a section of clear tubing that will fit snuggly over the valve stem - zip tie it to the stem. Have the tube long enough to hold half the beads (2.5oz), then use a quick jet of air from an air gun (not too hard) and the beads zip right in... do this twice on each wheel and you'll likely be done in 1/2 hour... Just don't get over zealous with the air gun and have those little bb's all over your garage floor.
Also - there is a place in Crystal Lake, IL that has the correct beads at $60 for 5 pounds + shipping - works out to about $1 per ounce - lots less than the parts houses (car or motorcycle). Do a group buy for your club and save bucks... they really do work.
This is the company that used to supply the name brand, until they started sourcing overseas... I bought a jar from them - nice people...
*******
Subject: Zirconium Beads
If you are using this for wheel balancing, the QBZ-58A would be your choice.
QBZ-58A 1.0 mm $ 60.00/quart
Quackenbush Co., Inc.
Scott Quackenbush
6711 Sands Rd
Crystal Lake, IL 60014
Ph: 815-479-8900 Fx: 815-479-9902
Web Site:
www.quackco.com