The Ford Barn - View Single Post

Tom Wesenberg · 04-09-2012, 01:44 AM

I just measured my Snyder's 5.5 head and an original stock head and they both measured exactly the same at 2.2275". The Snyder's head looks excellent in every way. It's still in the box it came in, but I don't foresee any problems and will use all original studs and nuts.

If it had been too high, then I would have milled the bosses down to the correct height.

04-09-2012, 01:44 AM	#58
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: Snyder's Head Problem I just measured my Snyder's 5.5 head and an original stock head and they both measured exactly the same at 2.2275". The Snyder's head looks excellent in every way. It's still in the box it came in, but I don't foresee any problems and will use all original studs and nuts. If it had been too high, then I would have milled the bosses down to the correct height.