The Ford Barn - View Single Post

flash9376 · 07-06-2010, 07:13 PM

Its a Zenith. I replaced all the jets and stuff on the inside. Its the original float and it doesnt seem to have any holes in it. Its adjusted to close at 5/8". I have the idle adjustment open to about 3 turns(1.5 to 3.5 turns is recommended) and the adjustment needle at 1 full turn to start. The engine idles fast and when i try to adjust the throttle it usually just stalls outs, doesnt even slow the engine down.

07-06-2010, 07:13 PM	#3
flash9376 Member Join Date: Jun 2010 Posts: 35	Re: carbuerator adjustments. Its a Zenith. I replaced all the jets and stuff on the inside. Its the original float and it doesnt seem to have any holes in it. Its adjusted to close at 5/8". I have the idle adjustment open to about 3 turns(1.5 to 3.5 turns is recommended) and the adjustment needle at 1 full turn to start. The engine idles fast and when i try to adjust the throttle it usually just stalls outs, doesnt even slow the engine down.