Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by hardtimes
J&M,
It's nice to know that YOU do the good work that you state and state logic that matches your good work. Wish your business was on the left coast!
I posted below before seeing you post, or I wouldn't have posted my thots, as you did a better job saying , in essence, same same.
One question: did you take down the dist mounting surface same amount , for dist shaft to fit accurately...or wasn't that necessary?
|
We've haven't machined the boss for the distributor as we've found that it's ok where it's at.