[Kohnke Rebabbitting]

Good Grief, There are lots of companies that pour engine cast. finding a U.S. Co. to pour is easy, its the mold that has to be made right, as far as venting to make them fill out in all corners, and the right amount of shrinkage that is needed. So if the mold isn't right, the pours will be bad. The final say on where it will be cast at, ALWAYS COMES DOWN TO MONEY! But it is the Responsibility of who ever had a product made, to make sure the item is made right, before ther put out for sale, not just to recoup your losses on the flawed batch. What would you say, these are made with flaws, but they are good enough for you, you can always wait for the next batch, and buy a good one at the same price. I wonder who would except a flawed bearing from me! Should I say, better luck next time!