03-09-2012, 10:42 AM
|
#8
|
|
Senior Member
Join Date: Dec 2010
Location: FRESNO, CA
Posts: 12,560
|
Re: question pleasedistributor
Quote:
Originally Posted by Tom Wesenberg
Bill,
The lcok screw should not be that tight though. It should just touch the distributor, then tighten the lock nut.
|
Tight within reason, after all, the dist does have an IRON body! To be "safe," I grind a sharp point on the end of the screw for a little "bite." I've run them for years this way with NO problems. Works for me! Bill W.
__________________
"THE ASSISTANT GURU OF STUFF"
|
|
|