The Ford Barn - View Single Post - Threaded 2-piece crankshaft pulley

John LaVoy · 02-26-2012, 09:07 AM

Several years ago we reviewed the various crankshaft pulleys in the Model A Times. At that time all of the two piece units had problems with being either too short front to back or the diameter was incorrect allowing the oil to leak past the seal. Since then Snyder's has redone their two piece unit to match the dimensions in the Ford blue prints for the crankshaft pulley.

02-26-2012, 09:07 AM	#7
John LaVoy Senior Member Join Date: May 2010 Location: Rocklin, CA Posts: 1,219	Re: Threaded 2-piece crankshaft pulley Several years ago we reviewed the various crankshaft pulleys in the Model A Times. At that time all of the two piece units had problems with being either too short front to back or the diameter was incorrect allowing the oil to leak past the seal. Since then Snyder's has redone their two piece unit to match the dimensions in the Ford blue prints for the crankshaft pulley.