Quote:
Originally Posted by Ralph Moore
Another Cover? I purchased the Aluminum aftermarket Offenhauser front cover. Put your Chevy conversion Dist. in it. Fit was great, but I decided to go with early heads, so no way to hold dist down . A clamp is included with the cover, but due to the design of the chevy dist, the clamp would not tighten on it. My solution, a shim around the shaft, at the very top( made from plumbing supplies) crude, but it works!
|
Another way to do this is to drill two small holes in the collar of the cover. Thread it for some female allen head "plugs", use some loctite and you're good to go and can adjust it easily in the future.