[davo-usa]

Update. All went well with the install. Not too sure about the instructions that came with the kit. Juist started with the windlace and other trim pieces around the front of hte door. Start with putting the front of the headliner into the headboard area and then lifted the rear into the rubber seal of the rear glass. Make sure you're centered, not much of a chance of sliding around. I had to trim a little over the drivers door (maybe 3/16 for about 3"). The rear corner pieces were the easiest being mindfull of too much roll and not to crease. Be sure to count and divide hardware into two equal halfs and all should be ok. Oh, by the way it's a two person job!! Overall not a bad kit. Thanks for the replies.