[30Tudor]

I wanted to update this thread based on a question I asked earlier this year regarding building a shield for a "duck under" air filter assembly using a K&N 2040 filter.

I ended up building a shield using 4" heavy gauge galvanized heating duct as shown in the attached photos. It is cut out of one piece of tin and I soldered the tabs together on the one end . There is about a 3/4" gap between the top of the filter and the shield. The bottom is open.

I do get the occaisonal drip from my carb and at least now it is not soaking into the filter.

You can see in the pictures that I like filters!

I hope somebody can use this idea.